Vag Tacho 3.01 Driver Download

How to Install Vag Tacho 3.01 Drivers on Windows

Vag Tacho 3.01 is a software that allows you to read and program the immobilizer PIN code and mileage of various VAG group vehicles, such as Volkswagen, Audi, Seat and Skoda. It works with a USB interface cable that connects to the OBD port of your car. However, before you can use the software, you need to install the drivers for the cable on your Windows computer. In this article, we will show you how to do that step by step.

Step 1: Download the drivers

The first thing you need to do is to download the drivers for the Vag Tacho 3.01 cable from the FTDI website. FTDI is the company that makes the chipset in the cable. Depending on your Windows version and system type, you may need to download different drivers. For example, if you are running a 64-bit version of Windows 8, the latest driver may not work, but you can try an older version 2.08.28. You can find the drivers at the bottom of the FTDI website page, under "no longer supported".

Download Zip: https://riagrancrocku.blogspot.com/?qc=2w3Ww7

Step 2: Install the drivers

After you download the drivers, you need to install them on your computer. To do that, follow these steps:

• Unzip the downloaded file and extract the driver files to a folder on your computer.

• Connect the Vag Tacho 3.01 cable to your computer via a USB port. Your computer should detect the cable and try to install the drivers automatically.

• If the automatic installation fails, go to Device Manager and find the device with a yellow exclamation mark. It should be under "Other devices" or "Universal Serial Bus controllers". Right-click on it and select "Update driver software".

• Select "Browse my computer for driver software" and then "Let me pick from a list of device drivers on my computer".

• Click on "Have disk" and then "Browse". Navigate to the folder where you extracted the driver files and select the file with the extension ".inf". Click on "Open" and then "OK".

• Select the FTDI device from the list and click on "Next". Follow the instructions on the screen to complete the installation.

You can watch a video tutorial on how to install the drivers for Vag Tacho 3.01 on Windows 7 [here]. The procedure is similar for Windows XP, 8 and 10, but on Windows 10, the software may not run well.

Step 3: Run the software

Once you have installed the drivers, you can run the Vag Tacho 3.01 software on your computer. To do that, follow these steps:

• Make sure your car is turned off and connect the Vag Tacho 3.01 cable to its OBD port.

• Run the Vag Tacho 3.01 software as administrator on your computer.

• Select your car model and year from the drop-down menu.

• Click on "Connect Selected ECU" and wait for the software to communicate with your car.

• You can now read and program your immobilizer PIN code and mileage using the buttons on the software interface.

You can watch a video tutorial on how to run the software on a Seat Ibiza 2004 [here].

Conclusion

Vag Tacho 3.01 is a useful software for reading and programming your immobilizer PIN code and mileage of various VAG group vehicles. However, before you can use it, you need to install the drivers for the USB interface cable on your Windows computer. In this article, we showed you how to do that step by step. We hope this article was helpful for you. If you have any questions or comments, please feel free to leave them below.